The firmware of the WEXLER TAB 7iD tablet (8GB+3G) is made for the purpose of updating the software or to eliminate software malfunctions.
There are several types of software-related malfunctions: hanging, constant reboot when turned on, regular errors, etc. Before proceeding with the procedure, you need to download the WEXLER TAB 7iD firmware.
The firmware for the tablet can be found and downloaded on the official website of the manufacturer. You will also need to download the drivers to connect the tablet to the computer. As a rule, the driver folder is located in the same archive with the firmware.
It should be noted that the firmware drivers differ from the standard drivers that are used to connect and synchronize the device in normal mode. Be sure to prepare a USB cable to connect the tablet to the computer. The cable must be serviceable to ensure uninterrupted communication.
Important: The tablet must be fully charged! You cannot start the firmware if the battery has a low charge. It is also necessary to provide a stable power supply for the computer. It is advisable to perform the process on a laptop.
In principle, the process of firmware of the WEXLER TAB 7iD tablet (8GB+3G) is not complicated. Sometimes, when the tablet does not turn on, the reason may be hidden in a software failure. First of all, in this situation, the specified firmware process can solve the problem. However, if there is no confidence in the integrity of the hardware of the device and there is enough experience in repairing digital equipment, it is recommended not to try to flash the tablet yourself.
Firmware of the WEXLER TAB 7iD tablet (8GB+3G) – step-by-step instructions
- All important data should be saved on the computer.
- Next, turn off the tablet.
- Unpack the archive with the firmware. For the WEXLER TAB 7iD tablet, the firmware may have a size of about 0.2-0.4 GB.
- Open the Driver folder and run the installation file “InstallDriver.exe “.
- Wait for the drivers to be installed, after which you can close the window.
- Open the folder “SP_Flash_Tool”, where the launching file of the program that will perform the tablet firmware will be located. Run the file.
- Next, click on the “Scater-loading” button in the program, after which a browser window opens.
- Find the folder where the firmware is unpacked and select “MT6577_Android_scatter_emms.txt “. After selecting this file, the program will display information about all connected files.
- To start the firmware process, click on the “Firmware -> Upgrade” button.
- Files will be downloaded for several seconds. This process is displayed in the progress bar. For example, a strip of crimson color will pass to the end and stop at 0%. Then it will be possible to proceed with the tablet firmware.
- The tablet, which is in the off state, should be connected to the computer using a USB cable.
- Normally, the tablet should not turn on. After connecting, the firmware should start immediately. Which is reflected in the progress bar with a red stripe.
- On average, the firmware lasts about 5 minutes. At the end of the process, a window with a green circle will appear. At this point, the tablet firmware is considered completed.
- Then you can close the above window, and then the program itself.
- Disconnect the tablet from the computer and press the power button. The first tablet download may take longer than usual. No need to try to restart the tablet, you should wait for the full download.